Lab equipment can be identified in a number of traditions most commonly by labeling or picture. However the equipment is identified, it should be done in a method that does not damage the instrument and is stable.
Identification Using Labels
Get label machines from the office providing section of the department or institute in which the lab is located, an office supply store such as Staples or Office depository, or a large department store like Target.
Create a label according to manufacturer's information, building certain that the name of the company and serial number of the equipment is on the label. Further information might be required, so test with the department or equipment specialists at the institute. Usually, at least the name of the institute, be it a company or educational institution using the equipment, must be on the label as well as the serial number. The serial number must be in the instrument instructions or on the manufacturer's instrument label.
Place the label on the equipments (ultrasonic bath, Chemical Reactor Vessel, in a place where it can be easily seen or is secure. If placing it on a centrifuge, for occasion, putting it near the on/off switch may be good. Simply remove the paper back up on the label and place it on the instrument.
Keep away from certain areas if the instrument uses or tests mordant material. The back of the instrument, such as the back of the arm of a microscope, might be a good idea.
Labeling Using Etching
Use picture to permanently identify the instrument. An etching gun or engraver might be available at the equipment and provide office of your company or institution. You know how to buy one online from the Etching Metal Company and at a Lowe's Home Improvement Store.
Locate a place on the equipment that does not get touched often, nor is in contact with corrosive materials.
Make use of the etching device to imprint the company or institution name and serial number on the instrument frankly.
Use a metal label with company or institution name preprinted on it and etches the serial number on to the label. Attach the label to the equipment. If there is glue on the back side of the label, remove the caring paper and place on the instrument. If the label wants to be screwed into the machine, use minute screws and an electric screwdriver and any other essential materials to attach it to the equipment.
Labeling Using Hanging Placards
Use hanging placards if for various reason the laboratory equipment cannot have a label on it. This may be for the reason that the company or lab to which the equipment will be assigned has not been unwavering. These types of labels can be collected of index cards and string or twine.
Get an index card and write any essential information on it, such as the probable lab and department or institute to which the equipment will go.
Staple or tape sequence or twine to either of the peak corners of the index card. Hang on Medical laboratory instrument awaiting more destination information can be unwavering and a permanent label affixed to the instrument.
