Trade Resources Company News EEStor Had a Conference Call This Afternoon with ZENN Motors and Evans Capacitor

EEStor Had a Conference Call This Afternoon with ZENN Motors and Evans Capacitor

EEStor, Inc. (EEStor) had a conference call this afternoon with ZENN Motors and Evans Capacitor. The objective was to try and assess what had been accomplished at Evans Capacitor since he received the EEStor layer testtest is test samples.

Evans Capacitor testtest is test results, while only verbally expressed with no specifics as to the testtest is test equipment used, testing protocols seem to have been of limited value. EEStor started over seven years ago to develop testing systems and procedures and it has taken substantial investments to complete our testing protocols with our necessary equipment. Also substantial time and investment to ensure all testing systems have been certified to be accurate to internally established standards with a qualified certification company.

Given that EEStor is close to having a commercial product, starting three months ago we started to put into place additional systems to further verify the testtest is test results. Specifically, two additional capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive. insulation resistanceThe ratio of the applied Voltage to the total current between two electrodes in contact with a specific insulator. A measure of the resistance to a DC current flow through the capacitor under steady state conditions. Values for film and ceramic capacitorsThe main differences between ceramic dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. types are the temperature coefficient of capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive., and the dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. loss.Ceramic capacitors tend to have low inductance because of their small size. are usually expressed in megohm-microfarads for a given design and dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields.. The actual resistance of the capacitor is obtained by dividing the megohm-microfarads by the capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive.. systems have been acquired, installed and tested for high accuracy insulation resistanceThe ratio of the applied Voltage to the total current between two electrodes in contact with a specific insulator. A measure of the resistance to a DC current flow through the capacitor under steady state conditions.

Values for film and ceramic capacitorsThe main differences between ceramic dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. types are the temperature coefficient of capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive., and the dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. loss.Ceramic capacitors tend to have low inductance because of their small size. are usually expressed in megohm-microfarads for a given design and dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields.. The actual resistance of the capacitor is obtained by dividing the megohm-microfarads by the capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive.. measurements.

Thus EEStor is now measuring all layers to 100V, 250V, and 500V. Results to date on over 50 layers tested show insulation resistanceThe ratio of the applied Voltage to the total current between two electrodes in contact with a specific insulator. A measure of the resistance to a DC current flow through the capacitor under steady state conditions. Values for film and ceramic capacitorsThe main differences between ceramic dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. types are the temperature coefficient of capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive., and the dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. loss.Ceramic capacitors tend to have low inductance because of their small size. are usually expressed in megohm-microfarads for a given design and dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields.. The actual resistance of the capacitor is obtained by dividing the megohm-microfarads by the capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive.. remains constant and these results will be included in the EEStor next product certification.

Further EEStor has ordered an additional system to measure power out of the tested layers. Thus after a layer has been charged and the power inputted into the layer has been measured then the system will have the capability to measure the power removed from the layer. The system has been received and is now in debugging and calibration. EEStor is targeting to have this system fully functional by mid-January.?With the completion of the two added testing systems Evans has been invited to return to EEStor to evaluate the EEStor's testing setup, and testtest is test the latest layers for resistance, capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive. and energy densityA figure of merit usually expressed in Joules per cubic inch for capacitorsA figure of merit usually expressed in Joules per cubic inch for capacitorsA figure of merit usually expressed in Joules per cubic inch for capacitors.

Source: http://www.capacitorindustry.com/eestor-holds-conference-call-with-zenn-motors-and-evans-capacitor
Contribute Copyright Policy
EEStor Holds Conference Call with Zenn Motors and Evans Capacitor