More and More Safety Glasses Will Come out

The cleaning process of flat washer for tempered glass is simple relatively. The tanks can be feed with industrial water without heating. Because the surface of glass has not been made any treatment, there is no special requirement for the brushes on the glass washer. With the fast development of building industry and glass manufacturing, coated glass deep processing industry has also developed extensively. This article mainly describes the wide application of flat glass washing machine in the glass industry. At the same time, there is also no too restrictive requirement for water PH. About the air knife design, we can adopt normal structural but must ensure the wind power can be adjusted. The design of distance between rollers can not be considered making too large. Generally speaking, the factory could use middle or small washing machine to do the cleaning and drying job for raw piece of laminated glass. We can expect, along with social development in future, more and more safety glasses will come out and the horizontal washing machine would also be manufactured cooperatively with them and this industry will become more specific, detailed and standardized. The specific performance is that we are not only upgrade or improve the equipment structure, but also make the specific difference on brush manufacturing, selection of conveying rubber rollers, especially enable the studies of cleaning system and air knife structure meet different special requirements. Particularly after the solar glass, conductive glass, foam glass and other special glass are widely put into market, the factoies put forward higher cleaning requirements to above special glass. In the last decade, building glass has been developed in the direction of insulating, energy-saving, safety and decoration, so the horizontal washing machines are also improved with the same direction. Source: glasszng.com/blog