On January 30, 2014, KEMET Corporation (NYSE: KEM) will release earnings for the December 2013 quarter and will hold a conference call to discuss the earnings release at 9:00 a.m. EST on that date. The call will last approximately one hour.
To access the call via telephone, participants in the United States should dial 1-800-416-8033, and participants outside the United States should dial 1-706-643-0979.? Participants should reference "KEMET Corporation" and Conference ID #33024967.? Participants can view a corresponding presentation from the KEMET website at www.kemet.com by clicking on the conference call link in the Investor Relations section of the website.? The presentation will be available immediately prior to the beginning of the call.? Following management's comments, there will be an opportunity for questions.
In conjunction with the conference call, there will be a simultaneous live broadcast over the internet that can be accessed at http://irThe ratio of the applied Voltage to the total current between two electrodes in contact with a specific insulator. A measure of the resistance to a DC current flow through the capacitor under steady state conditions. Values for film and ceramic capacitorsThe main differences between ceramic dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. types are the temperature coefficient of capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive., and the dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields. loss.Ceramic capacitors tend to have low inductance because of their small size. are usually expressed in megohm-microfarads for a given design and dielectricThe insulating material between the plates of the capacitor. The material is chosen for its ability to permit electrostatic attraction and repulsion to take place across it. The material will have the property that energy required to establish an electric field is recoverable in whole or in part, as electric energy. In other words, a good dielectric material is a poor conductor of electricity while being an effective supporter of electrostatic fields.. The actual resistance of the capacitor is obtained by dividing the megohm-microfarads by the capacitanceThat property of a system of conductors and dielectrics which permits the storage of electricity when potential difference exists between the conductors. Its value is expressed as the ratio of a quantity of electricity to a potential difference. A capacitance value is always positive...kemet.com/. ?A replay of the conference call will be available until midnight, February 13, 2014, through the same link.
