LEDs Emit Light in a Very Small Band of Wavelengths

General-purpose lighting needs white light. LEDs emit light in a very small band of wavelengths, emitting light of a color characteristic of the energy bandgap of the semiconductor material used to make the LED. To emit white light from LEDs requires either mixing light from red, green, and blue LEDs, or using a phosphor to convert some of the light to other colors. The first method (RGB-LEDs) uses multiple LED chips, each emitting a different wavelength, in close proximity to generate the broad spectrum of white light. The advantage of this method is that the intensity of each LED can be adjusted to "tune" the character of the light emitted. The major disadvantage is high production cost. The character of the light can be changed dynamically by adjusting the power supplied to the different LEDs. The second method, phosphor converted LEDs (pcLEDs) uses one short wavelength LED (usually blue or ultraviolet) in combination with a phosphor which absorbs a portion of the blue light and emits a broader spectrum of white light. (The mechanism is similar to the way a fluorescent lamp emits white light from a UV-illuminated phosphor.) The major advantage is the low production cost, and high CRI (color rendering index), but the phosphor conversion reduces the efficiency of the device. The character of the light cannot be changed dynamically. The low cost and adequate performance makes it the most widely used technology for general lighting today. A single LED is a low-voltage solid state device and cannot be directly operated on standard high-voltage AC power without circuitry to control the voltage applied and the current flow through the lamp. In principle a series diode and resistor could be used to control the voltage polarity and to limit the current, but this would be very inefficient since most of the applied power would be dissipated by the resistor. A series string of LEDs would minimize dropped-voltage losses, but one LED failure would extinguish the whole string. Paralleled strings increase reliability by providing redundancy. In practice, three or more strings are usually used. To be useful for illumination a number of LEDs must be placed close together in a lamp to combine their illuminating effects because, as of 2011[update], the largest available LEDs emit only a small fraction of the light of traditional light sources. When using the color-mixing method a uniform color distribution can be difficult to achieve, while the arrangement of white LEDs is not critical for color balance. Further, degradation of different LEDs at various times in a color-mixed lamp can lead to an uneven color output. LED lamps usually consist of clusters of LEDs in a housing with driver electronics, a heat sink, and optics. Source:en.wikipedia.org